Dell SmartFabric OS10 User Guide Release 10.5.3

Configure an access PVLAN port as tagged member of regular VLANs

You can configure an access PVLAN port as tagged member of regular VLANs.

1. Enter Configuration mode.

   OS10# configure terminal

2. Enter Interface Configuration mode.

   OS10(config)# interface ethernet 1/1/1

3. Configure the port as a promiscuous port.

   OS10(conf-if-eth1/1/1)# private-vlan mode promiscuous

   You can configure the Switchport mode as a promiscuous or secondary port.

   OS10(conf-if-eth1/1/1)# show configuration
   ! 
   interface ethernet1/1/1 
   no shutdown
   private-vlan mode promiscuous
   switchport access vlan 1
   OS10(conf-if-eth1/1/1)#

   NOTE: Notice that the port continues to be in the default VLAN, even though it is in PVLAN mode.
4. Associate the promiscuous port to a primary VLAN.

   OS10(conf-if-eth1/1/1)# switchport access vlan 10

5. Configure the Switchport mode as trunk to carry traffic from more than a single VLAN.

   OS10(conf-if-eth1/1/1)# switchport mode trunk

6. Associate the port to be a trunk member of regular VLAN.

   OS10(conf-if-eth1/1/1)# switchport trunk allowed vlan 100

   OS10(conf-if-eth1/1/1)# show configuration 
   ! 
   interface ethernet1/1/1 
   no shutdown 
   private-vlan mode promiscuous
   switchport access vlan 10
   switchport trunk allowed vlan 100
   OS10(conf-if-eth1/1/1)#