Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Configuring delay-restore port - non-VLT

Following table shows how to configure delay-restore ports on an interface and with a timer value:

Table 1. Configuring delay-restore port on an interfaceConfiguring delay-restore port on an interface
Step Command Description
1 OS10# configure terminal Enters Configuration mode.
2 OS10(config)# interface ethernet 1/1/1 Enters Interface configuration mode.
3 OS10(conf-if-eth1/1/1)# delay-restore-port enable Enables delay-restore port.
4 OS10(conf-if-eth1/1/1)# exit Exits Interface configuration mode and enters Configuration mode.
5 OS10(conf)# delay-restore-port timeout 120 Configures delay-restore port timer to 120s.

Consider this switch is reloaded. On boot up, ethernet1/1/1 is kept down. The delay-restore timer is started and is run for 120 seconds. After the timer expires, ethernet1/1/1 is brought up.

You can use the following show command to view the current state of configurations and the timer: 

OS10# show delay-restore-port
Delay-Restore Port timer              : 90 seconds
Remaining time                        : 57 seconds
Delay-Restore Port enabled interfaces : Eth1/1/1

The following table lists the steps to disable delay-restore port on an interface and shows how to revert the timer value to default:

Table 2. Disable delay-restore portDisable delay-restore port
Step Command Description
1 OS10# configure terminal Enters Configuration mode.
2 OS10(config)# interface ethernet 1/1/1 Enters Interface configuration mode.
3 OS10(conf-if-eth1/1/1)# no delay-restore-port enable Disables delay-restore port.
4 OS10(conf-if-eth1/1/1)# exit Exits Interface configuration mode and enters Configuration mode.
5 OS10(conf)# no delay-restore-port timeout Reverts delay-restore timer value to default 90s.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\