Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Configure an IPv4 address and local proxy ARP on a PVLAN interface

Enable the Local Proxy ARP feature in the primary VLAN to allow communication between isolated hosts and between hosts connected to different community VLANs within the same PVLAN domain.

You can configure a Layer 3 (L3) VLAN interface, assign an IPv4 address, and enable local proxy ARP in the primary VLAN.

NOTE: To enable the Local Proxy ARP feature, you must assign an IPv4 address to the primary VLAN.
  1. Enter Configuration mode. 
    OS10# configure terminal
  2. Enter VLAN Interface mode. 
    OS10(config)# interface vlan 10
  3. Configure an IP address. 
    OS10(conf-if-vl-10)# ip address 10.1.1.1/24
  4. Enable the local proxy ARP in the primary VLAN. 
    OS10(conf-if-vl-10)# ip local-proxy-arp
    OS10(conf-if-vl-10)# show configuration
! 
interface vlan10
private-vlan mode primary
private-vlan mapping secondary-vlans 20, 30
no shutdown
ip address 10.1.1.1/24
ip local-proxy-arp 
OS10(conf-if-vl-10)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\