Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

flow-based enable

Enable flow-based monitoring.

Syntax

flow-based enable

To disable flow-based monitoring, use the no flow-based enable command.

Defaults

Disabled, that is flow-based monitoring is not applied.

Command Modes

MONITOR SESSION (conf-mon- sess-session-ID)

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Added support for the RPM/ERPM.
9.3(0.0)	Introduced on the MXL 10/40GbE Switch IO Module platform.
8.1.1.0	Introduced on the E-Series ExaScale.
7.4.1.0	Introduced on the E-Series.

Usage Information

To monitor traffic with particular flows the interface, appropriate ACLs has be applied in ingress direction. Flow- based is not supported in the tx direction. Even though we can configure it in both the direction, only rx will work.

The flow- based enable command has to be applied as a monitor session with some configuration which is already present in it, other wise flow- based will not take effect.

Related Commands

monitor session – enables a monitoring session.