Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

protocol-tunnel rate-limit

Enable traffic rate limiting per box.

Syntax

protocol-tunnel rate-limit rate

To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.

Parameters

rate

Enter the rate in frames per second. The range is from 75 to 3000. The default is 75.

Defaults

75 frames per second.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch Mode

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell#
                                             Dell#conf
                                             Dell(conf)#protocol-tunnel rate-limit 1000
                                             Dell(conf)#

Related Commands

show protocol-tunnel — displays tunneling information for all VLANs.

show running-config — displays the current configuration.