Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

logging

Configure an IP address or host name of a Syslog server where logging messages are sent. You can configure multiple logging servers of both IPv4 and/or IPv6.

Syntax logging { ip-address | ipv6–address | hostname} {{udp { port}} | {tcp { port}}

To disable logging, use the no logging command.

Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
  • NOTE: The :: notation specifies successive hexadecimal fields of zeros.
hostname Enter the name of a host already configured and recognized by the switch.
udp    Enter the keyword udp to enable transmission of log message over UDP followed by port number. The default port is 514
tcp                           Enter the keyword tcp to enable transmission of log message over TCP followed by port number.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced udp and tcp keywords on the MXL 10/40GbE Switch.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands

logging on — enables the logging asynchronously to logging buffer, console, Syslog server, and terminal lines.

logging trap — enables logging to the Syslog server based on severity.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\