Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor soft-reconfiguration inbound

Enable soft-reconfiguration for BGP.

Syntax

neighbor { ip-address | peer-group-name} soft-reconfiguration inbound

To disable, use the no neighbor { ip-address | peer-group-name} soft-reconfiguration inbound command.

Parameters

ip-address	Enter the IP address of the neighbor in dotted decimal format.
peer-group-name	Enter the name of the peer group to disable or enable all routers within the peer group.

Defaults

Disabled

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This command enables soft-reconfiguration for the BGP neighbor specified. BGP stores all the updates the neighbor receives but does not reset the peer-session.

CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update database from the neighbor is stored in memory regardless of the inbound policy results applied on the neighbor.

NOTE: This command is supported in BGP Router Configuration mode for IPv4 Unicast address only.

Related Commands

show ip bgp neighbors — displays routes received by a neighbor.