Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

qos-policy-output ets

To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.

Syntax

qos-policy-output policy-name ets

To remove the QoS output policy, use the no qos-policy-output ets command.

Parameters

policy-name

Enter the policy name. The maximum is 32 characters.

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If an error occurs in an ETS output-policy configuration, the configuration is ignored and the scheduler and bandwidth allocation settings are reset to the ETS default values (all priorities are in the same ETS priority group and bandwidth is allocated equally to each priority).

If an error occurs when a port receives a peer’s ETS configuration, the port’s configuration is reset to the previously configured ETS output policy. If no ETS output policy was previously applied, the port is reset to the default ETS parameters.

Related Commands

scheduler — schedules the priority traffic in port queues.
bandwidth-percentage — bandwidth percentage allocated to the priority traffic in port queues.