Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

network

Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this command.

Syntax

network ip-address

To disable RIP for a network, use the no network ip-address command.

Parameters

ip-address

Specify an IP network address in dotted decimal format. You cannot specify a subnet.

Defaults

No RIP network is configured.

Command Modes

ROUTER RIP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

You can enable an unlimited number of RIP networks.

RIP operates over interfaces configured with any address the network command specifies.