Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show tdr

Displays the TDR test results.

Syntax

show tdr interface

Parameters

interface

Enter the keyword TenGigabitEthernet followed by the slot/port information for the 100/1000/10 GbaseT Ethernet interface.

Defaults

none

Command Modes

EXEC

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

If the TDR test has not been run, an error message is generated:

%Error: Please run the TDR test first

The following describes the TDR test status.

Status	Definition
OK Status: Terminated	TDR test is complete, no fault is detected on the cable, and the test is terminated.
Length: 92 (+/- 1) meters, Status: Shorted	A short is detected on the cable. The location, in this Example is 92 meters. The short is accurate to plus or minus one meter.
Length: 93 (+/- 1) meters, Status: Open	An opening is detected on the cable. The location, in this Example is 93 meters. The open is accurate to plus or minus one meter.
Status: Impedance Mismatch	There is an impedance mismatch in the cables.

Example

Related Commands

tdr-cable-test — Runs the TDR test.