Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show cpu-traffic-stats

Display the CPU traffic statistics.

Syntax

show cpu-traffic-stats [ port number | all]

Parameters

port number	(OPTIONAL) Enter the port number to display traffic statistics on that port only. The range is from 1 to 1568.
all	(OPTIONAL) Enter the keyword `all` to display traffic statistics on all the interfaces receiving traffic, sorted based on the traffic.

Defaults

all

Command Modes

EXEC

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed first. All CPU and port information is displayed unless a specific port or CPU is specified. Traffic information is displayed for router ports only; not for management interfaces. The traffic statistics are collected only after the debug cpu-traffic-stats command is executed; not from the system bootup.

NOTE: After debugging is complete, use the no debug cpu-traffic-stats command to shut off traffic statistics collection.

Example

Dell#show cpu-traffic-stats
                                             Processor : CP
                                             --------------
                                             Received 100% traffic on TenGigabitEthernet 8/2 Total packets:100
                                             LLC:0, SNAP:0, IP:100, ARP:0, other:0
                                             Unicast:100, Multicast:0, Broadcast:0
                                             Dell#

Related Commands

debug cpu-traffic-stats — enables CPU traffic statistics for debugging.