Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

untagged

Add a Layer 2 interface to a VLAN as an untagged interface.

Syntax

untagged interface

To remove an untagged interface from a VLAN, use the no untagged interface command.

Parameters

interface

Enter the following keywords and slot/port or number information:

For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

Defaults

All interfaces in Layer 2 mode are untagged.

Command Modes

INTERFACE VLAN

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Untagged interfaces can only belong to one VLAN.

In the Default VLAN, you cannot use the no untagged interface command. To remove an untagged interface from all VLANs, including the Default VLAN, enter INTERFACE mode and use the no switchport command.

Related Commands

interface vlan — configures a VLAN.

tagged — specifies which interfaces in a VLAN are tagged.