Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

redirect

Configure a rule for the redirect list.

Syntax redirect { ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>]{ ip-protocol-number | protocol-type [ bit]} { source mask | any | host ip-address} { destination mask | any | host ip-address} [ operator]
To remove this filter, use one of the following:
  • Use the no seq sequence-number command if you know the filter’s sequence number.
  • You can also use the no redirect { ip-address | slot/port}| tunnel tunnel-id}[track <obj-id>]{ ip-protocol-number [ bit] | protocol-type} { source mask | any | host ip-address} { destination mask | any | host ip-address} [ operator] command.
Parameters
ip-address Enter the IP address of the forwarding router.
slot/port Enter the keyword slot / port followed by the slot/port information.
ip-protocol-number Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
tunnel Enter the keyword tunnel to configure the tunnel setting.
tunnel-id Enter the keyword tunnel-id to redirect the traffic.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
protocol-type Enter one of the following keywords as the protocol type:
  • icmp for internet control message protocol
  • ip for any internet protocol
  • tcp for transmission control protocol
  • udp for user datagram protocol
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following TCP flags:
  • ack = acknowledgement
  • fin = finish (no more data from the user)
  • psh = push function
  • rst = reset the connection
  • syn = synchronize sequence number
  • urg = urgent field
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand:
  • eq = equal to
  • neq = not equal to
  • gt = greater than
  • lt = less than
  • range = inclusive range of ports (you must specify two ports for the port command parameter.)
Defaults none
Command Modes REDIRECT-LIST
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added the keyword track-id on the MXL.
9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1 Introduced on the C-Series.
8.4.2.0 Introduced on the E-Series TeraScale.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\