Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

resequence prefix-list ipv4

Re-assign sequence numbers to entries of an existing prefix list.

Syntax

resequence prefix-list ipv4 { prefix-list-name StartingSeqNum Step-to-increment }

Parameters

prefix-list-name	Enter the name of the configured prefix list, up to 140 characters long.
StartingSeqNum	Enter the starting sequence number to resequence. The range is from 0 to 65535.
Step-to-Increment	Enter the step to increment the sequence number. The range is from 1 to 65535.

Defaults

none

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence number to entries of an existing prefix list.

Related Commands

seq — Assigns a sequence number to a deny or permit filter in an IP access list while creating the filter.