Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

stack-unit renumber

Change the stack member ID of any stack member or a stand-alone unit.

Syntax

stack-unit 0-5 renumber 0-5

Parameters

0-5	The first instance of this value is the stack member unit identifier, from 0 to 5, of the switch that you want add to the stack. The range is from 0 to 5. The second instance of this value is the desired new unit identifier number.

Defaults

none

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6.(0.0)	Supported on the FN I/O Aggregator.
9.3(0.0)	Supported on the M I/O Aggregator.

Usage Information

This command is supported on the FN410S and the FN410T Aggregators.

You can renumber any switch, including the management unit or a stand-alone unit.

You cannot renumber a unit to a number of an active member in the stack.

When executing this command on the master, the stack reloads. When the members are renumbered, only that specific unit is reset and comes up with the new unit number.

Example

Dell#stack-unit 5 renumber 4
                                             
                                             Renumbering will reset the unit.
                                             Warning: Interface configuration for current unit will be lost!
                                             Proceed to renumber [confirm yes/no]:

Related Commands

reload – reboots Dell Networking Operating System (OS).
reset stack-unit – resets the designated stack member.
show system – displays the current status of all stack members or a specific member.