Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

switchport mode private-vlan

Set PVLAN mode of the selected port.

Syntax

[no] switchport mode private-vlan {host | promiscuous | trunk}

To remove PVLAN mode from the selected port, use the no switchport mode private-vlan command.

Parameters

host	Enter the keyword `host` to configure the selected port or port channel as an isolated interface in a PVLAN.
promiscuous	Enter the keyword `promiscuous` to configure the selected port or port channel as an promiscuous interface.
trunk	Enter the keyword `trunk` to configure the selected port or port channel as a trunk port in a PVLAN.

Defaults

Disabled.

Command Modes

INTERFACE

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The assignment of the various PVLAN port types to port and port channel (LAG) interfaces is shown in the following example.

Example

Dell#conf
                                             Dell(conf)#interface GigabitEthernet 2/1
                                             Dell(conf-if-te-2/1)#switchport mode private-vlan promiscuous
                                             
                                             Dell(conf)#interface GigabitEthernet 2/2
                                             Dell(conf-if-te-2/2)#switchport mode private-vlan host
                                             
                                             Dell(conf)#interface GigabitEthernet 2/3
                                             Dell(conf-if-te-2/3)#switchport mode private-vlan trunk
                                             
                                             Dell(conf)#interface port-channel 10
                                             Dell(conf-if-te-2/3)#switchport mode private-vlan promiscuous

Related Commands

private-vlan mode — sets the mode of the selected VLAN to community, isolated, or primary.

private-vlan mapping secondary-vlan — sets the mode of the selected VLAN to primary and then associates the secondary VLANs to it.

show interfaces private-vlan — displays type and status of PVLAN interfaces.

show vlan private-vlan mapping — displays the primary-secondary VLAN mapping.