Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

bfd interval

Specify non-default BFD session parameters beginning with the transmission interval.

Syntax

bfd interval interval min_rx min_rx multiplier value role {active | passive}

Parameters

interval milliseconds	Enter the keywords `interval` to specify non-default BFD session parameters beginning with the transmission interval. The range is from 50 to 1000. The default is 200.
min_rx milliseconds	Enter the keywords `min_rx` to specify the minimum rate at which the local system would like to receive control packets from the remote system. The range is from 50 to 1000. The default is 200.
multiplier value	Enter the keywords `multiplier` to specify the number of packets that must be missed in order to declare a session down. The range is from 3 to 50. The default is 3.
role [active \| passive]	Enter the role that the local system assumes: `Active` — The active system initiates the BFD session. Both systems can be active for the same session. `Passive` — The passive system does not initiate a session. It only responds to a request for session initialization from the active system. The default is Active.

Defaults

Refer to Parameters.

Command Modes

INTERFACE

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell(conf-if-gi-0/3)#bfd interval 250 min_rx 300 multiplier 4 role passive
                                             Dell(conf-if-gi-0/3)#