Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

Important Points to Remember

• Interface commands can only be applied on physical interfaces (virtual local area networks [VLANs] and link aggregation group [LAG] interfaces are not supported).
• An INTERFACE-level command only supports storm control configuration on ingress.
• An INTERFACE-level command overrides any CONFIGURATION-level ingress command for that physical interface, if both are configured.
• You can apply the CONFIGURATION-level storm control commands at ingress or egress and are supported on all physical interfaces.
• When storm control is applied on an interface, the percentage of storm control applied is calculated based on the advertised rate of the line card. It is not based on the speed setting for the line card.
• Do not apply per-VLAN quality of service (QoS) on an interface that has storm control enabled (either on an interface or globally).
• When you enable broadcast storm control on an interface or globally on ingress, and DSCP marking for a DSCP value 1 is configured for the data traffic, the traffic goes to queue 1 instead of queue 0.
• Similarly, if you enable unicast storm control on an interface or globally on ingress, and DSCP marking for a DSCP value 2 is configured for the data traffic, the traffic goes to queue 2 instead of queue 0.