Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip pim neighbor

View PIM neighbors.

Syntax

show ip pim neighbor

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full—Swtich

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip pim neighbor command shown in the following example.

Field	Description
Neighbor address	Displays the IP address of the PIM neighbor.
Interface	List the interface type, with either slot/port information or ID (VLAN or Port Channel), on which the PIM neighbor was found.
Uptime/expires	Displays the amount of time the neighbor has been up then the amount of time until the neighbor is removed from the multicast routing table (that is, until the neighbor hold time expires).
Ver	Displays the PIM version number. v2 = PIM version 2
DR prio/Mode	Displays the Designated Router priority and the mode. 1 = default Designated Router priority (use the `ip pim dr-priority` command) DR = Designated Router S = Sparse mode

Example

Dell#show ip pim neighbor
                                             Neighbor   Interface  Uptime/Expires    Ver   DR
                                             Address                                       Prio/Mode
                                             127.87.3.4 te 1/7    09:44:58/00:01:24  v2   1 / S
                                             Dell#