Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

redirect

Configure a rule for the redirect list.

Syntax

redirect { ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>]{ ip-protocol-number | protocol-type [ bit]} { source mask | any | host ip-address} { destination mask | any | host ip-address} [ operator]

To remove this filter, use one of the following:

Use the no seq sequence-number command if you know the filter’s sequence number.
You can also use the no redirect { ip-address | slot/port}| tunnel tunnel-id}[track <obj-id>]{ ip-protocol-number [ bit] | protocol-type} { source mask | any | host ip-address} { destination mask | any | host ip-address} [ operator] command.

Parameters

ip-address	Enter the IP address of the forwarding router.
slot/port	Enter the keyword `slot / port` followed by the slot/port information.
ip-protocol-number	Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
tunnel	Enter the keyword `tunnel` to configure the tunnel setting.
tunnel-id	Enter the keyword `tunnel-id` to redirect the traffic.
track	Enter the keyword `track` to enable the tracking.
track <obj-id>	Enter the keyword `track <obj-id>` to track object-id.
protocol-type	Enter one of the following keywords as the protocol type: `icmp` for internet control message protocol `ip` for any internet protocol `tcp` for transmission control protocol `udp` for user datagram protocol
bit	(OPTIONAL) For the TCP protocol type only, enter one or a combination of the following TCP flags: `ack` = acknowledgement `fin` = finish (no more data from the user) `psh` = push function `rst` = reset the connection `syn` = synchronize sequence number `urg` = urgent field
source	Enter the IP address of the network or host from which the packets were sent.
mask	Enter a network mask in /prefix format (/x).
any	Enter the keyword `any` to specify that all traffic is subject to the filter.
host ip-address	Enter the keyword `host` then the IP address to specify a host IP address.
destination	Enter the IP address of the network or host to which the packets are sent.
operator	(OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: `eq` = equal to `neq` = not equal to `gt` = greater than `lt` = less than `range` = inclusive range of ports (you must specify two ports for the `port` command parameter.)

Defaults

none

Command Modes

REDIRECT-LIST

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.7(0.0)	Added the keyword `track-id` on the MXL.
9.4(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1	Introduced on the C-Series.
8.4.2.0	Introduced on the E-Series TeraScale.