Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

management route

Configure a static route that points to the Management interface or a forwarding router.

Syntax

management route {ipv4-address | ipv6–address}/mask {forwarding-router-address | managementethernet}

Parameters

{ipv4-address \| ipv6–address}/ mask	Enter an IPv4 address (A.B.C.D) or the IPv6 address followed by the prefix-length for the IP address of the management interface.
forwarding-router-address	Enter an IPv4 address of a forwarding router.
managementethernet	Enter the keyword `managementethernet` for the Management interface.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.

Usage Information

When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 management routes. This command manages both tables.