Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip pim snooping neighbor

Display information on PIM neighbors learned through PIM-SM snooping.

Syntax

show ip pim snooping neighbor [vlan vlan-id]

Parameters

vlan vlan-id

(OPTIONAL) Enter a VLAN ID to display information about PIM neighbors that PIM-SM snooping discovered on a specified VLAN. The valid VLAN IDs range is from 1 to 4094.

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full—Swtich

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip pim snooping neighbor commands shown in the following example.

Field	Description
Neighbor address	Displays the IP address of the neighbor learned through PIM-SM snooping.
Interface	Displays the VLAN ID number and slot/port on which the PIM-SM-enabled neighbor was discovered.
Uptime/expires	Displays the amount of time the neighbor has been up then the amount of time until the neighbor is removed from the multicast routing table (that is, until the neighbor hold time expires).
Ver	Displays the PIM version number: v2 = PIM version 2
DR prio/Mode	Displays the Designated Router priority and the mode: 1 = default Designated Router priority (use the `ip pim dr-priority` command) DR = Designated Router S = Sparse mode

Example

Dell#show ip pim snooping neighbor
                                             
                                             Neighbor    Interface          Uptime/Expires    Ver  DR Prio
                                             Address
                                             165.87.32.2   Vl 2 [tei 4/8 ]  00:04:03/00:01:42  v2  1
                                             165.87.32.10  Vl 2 [te 4/8 ]  00:00:46/00:01:29  v2  0
                                             165.87.32.12  Vl 2 [te 4/8 ]  00:00:51/00:01:24  v2  0