Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

do

Allows the execution of most EXEC-level commands from all CONFIGURATION levels without returning to the EXEC level.

Syntax

do command

Parameters

command

Enter an EXEC-level command.

Defaults

none

Command Modes

CONFIGURATION
INTERFACE

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following commands are not supported by the do command:

enable
disable
exit
config

Example

Dell(conf-if-te-3/1)#do clear counters
                                             Clear counters on all interfaces [confirm]
                                             Dell(conf-if-te-3/1)#
                                             Dell(conf-if-te-3/1)#do clear logging
                                             Clear logging buffer [confirm]
                                             Dell(conf-if-te-3/1)#
                                             Dell(conf-if-te-3/1)#do reload
                                             System configuration has been modified. Save? [yes/no]: n
                                             Proceed with reload [confirm yes/no]: n
                                             Dell(conf-if-te-3/1)#