Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip pim snooping interface

Display information on VLAN interfaces with PIM-SM snooping enabled.

Syntax

show ip pim snooping interface [vlan vlan-id]

Parameters

vlan vlan-id

(OPTIONAL) Enter a VLAN ID to display information about a specified VLAN configured for PIM-SM snooping. The valid VLAN IDs range is from 1 to 4094.

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full—Swtich

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip pim snooping interface commands shown in the following example.

Field	Description
Interface	Displays the VLAN interfaces with PIM-SM snooping enabled.
Ver/Mode	Displays the PIM version number for each VLAN interface with PIM-SM snooping enabled: v2 = PIM version 2 S = PIM Sparse mode
Nbr Count	Displays the number of neighbors learned through PIM-SM snooping on the interface.
DR Prio	Displays the Designated Router priority value configured on the interface ( `ip pim dr-priority` command).
DR	Displays the IP address of the Designated Router for that interface.

Example (#2)

Dell#show ip pim snooping interface
                                             Interface Ver Nbr    DR    DR
                                             Count  Prio
                                             Vlan 2    v2  3      1     165.87.32.2