Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip ospf topology

Display routers in directly connected areas.

Syntax

show ip ospf process-id topology

Parameters

process-id

Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process.

Defaults

none

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To isolate problems with inter-area and external routes, use this command. In OSPF inter-area and external routes are calculated by adding LSA cost to the cost of reaching the router. If an inter-area or external route is not of correct cost, the display can determine if the path to the originating router is correct or not.

Example

Dell#show ip ospf 1 topology
                                             
                                             Router ID  Flags Cost  Nexthop   Interface Area
                                             3.3.3.3    E/B/-/ 1    20.0.0.3  Te 0/6   0
                                             1.1.1.1    E/-/-/ 1    10.0.0.1  Te 0/6    1
                                             Dell#