Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

timers bgp

Allows you to adjust the BGP network timers for all neighbors.

Syntax

timers bgp keepalive holdtimer

To return to the default values, use the no timers bgp command.

Parameters

keepalive	Enter the time interval (in seconds) between which the system sends keepalive messages. The range is from 1 to 65535. The default is 60 seconds.
holdtimer	Enter the time interval (in seconds) that the the system waits since the last keepalive message before declaring a BGP peer dead. The range is from 3 to 65535. The default is 180 seconds.

Defaults

keepalive = 60 seconds
holdtimer = 180 seconds

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

neighbor timers — adjusts BGP timers for a specific peer or peer group.