Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

clear hardware stack-unit

Clear statistics from selected hardware components.

Syntax

clear hardware stack-unit 0–5 {counters | unit 0–1 counters | cpu data-plane statistics | stack-port 9–12}

Parameters

stack-unit 0–5	Enter the keywords `stack-unit` then 0 to 5 to select a particular stack member and then enter one of the following command options to clear a specific collection of data.
counters	Enter the keyword `counters` to clear the counters on the selected stack member.
unit 0–0 counters	Enter the keyword `unit` along with a port-pipe number, from 0 to 1 , then the keyword `counters` to clear the counters on the selected port-pipe.
cpu data-plane statistics	Enter the keywords `cpu data-plane statistics` to clear the data plane statistics.
stack-port 9–12	Enter the keywords `stack-port` then the port number of the stacking port to clear the statistics of the particular stacking port. The range is from 9 to 12. NOTE: You can identify stack port numbers by physical inspection of the rear modules. The numbering is the same as for the 10G ports. You can also inspect the output of the `show system stack-ports` command.

Defaults

none

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.

Related Commands

show diag — displays the data plane or management plane input and output statistics of the designated component of the designated stack member.