Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ssh

Open an SSH connection specifying the host name, username, port number and version of the SSH client.

Dell Networking OS supports both inbound and outbound SSH sessions using IPv4 addressing. Inbound SSH supports accessing the system through the management interface as well as through a physical Layer 3 interface.

Syntax

ssh { hostname | ipv4 address} [-| username | -p port-number|-v {1|2}]

Parameters

hostname	(OPTIONAL) Enter the IP address or the host name of the remote device.
ipv4 address	(OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
-l username	(OPTIONAL) Enter the keyword `-l` followed by the user name used in this SSH session. The default is the user name of the user associated with the terminal.
-p port-number	(OPTIONAL) Enter the keyword `-p` followed by the port number. The range is from 1 to 65536. The default is 22.
-v {1 \| 2}	(OPTIONAL) Enter the keyword `-v` then the SSH version 1 or 2. The default is the version from the protocol negotiation.

Defaults

As shown in the Parameters section.

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.10(0.0)	Removed the support for hmac-sha2-256-96 algorithm.
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.

Example

Dell#ssh 123.12.1.123 -l ashwani -p 5005 -v 2