Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

remark

Enter a description for an ACL entry.

Syntax

remark [ remark-number] [ description]

Parameters

remark-number	Enter the remark number. The range is from 0 to 4294967290. NOTE: You can use the same sequence number for the remark and an ACL rule.
description	Enter a description of up to 80 characters.

Defaults

Not configured.

Command Modes

CONFIGURATION-IP ACCESS-LIST-STANDARD
CONFIGURATION-IP ACCESS-LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The remark command is available in each ACL mode. You can configure up to 4294967290 remarks in a given ACL.

The following example shows the use of the remark command twice within CONFIGURATION-STANDARD-ACCESS-LIST mode. The same sequence number was used for the remark and for an associated ACL rule. The remark precedes the rule in the running-config because it is assumed that the remark is for the rule with the same sequence number, or the group of rules that follow the remark.

Example

Dell(conf-std-nacl)#remark 10 Deny rest of the traffic
                                             Dell(conf-std-nacl)#remark 5 Permit traffic from XYZ Inc.
                                             Dell(conf-std-nacl)#show config
                                             !
                                             ip access-list standard test
                                             remark 5 Permit traffic from XYZ Inc.
                                             seq 5 permit 1.1.1.0/24
                                             remark 10 Deny rest of the traffic
                                             seq 10 Deny any
                                             Dell(conf-std-nacl)#

Related Commands

resequence access-list — Re-assigns sequence numbers to entries of an existing access-list.