Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

interface vlan

Configure a VLAN. Configure the default VLAN to enable Static or DCHP IP configuration. You can configure up to 4094 VLANs.

Syntax

interface vlan vlan-id

To delete a VLAN, use the no interface vlan vlan-id command.

Parameters

vlan-id

Enter 1 for the default VLAN. Enter a number as the VLAN identifier. The range is from 1 to 4096.

Defaults

Not configured, except for the default VLAN, which is configured as VLAN 1.

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

For more information about VLANs and the commands to configure them, refer to Virtual LAN (VLAN) Commands .

FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are not supported.

Examples

Dell(conf)#int vlan 1
                                             Dell(conf-if-vl-1)#

Dell(conf)#int vlan 3
                                             Dell(conf-if-vl-3)#

Related commands

show vlan — Displays the current VLAN configuration on the switch.

vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.

vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.