Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

set extcommunity soo

To set extended community site-of-origin in Route Map, use this feature.

Syntax

set extcommunity soo {as4 ASN4:NN | ASN:NNNN | IPADDR:NN [non-trans]}

To delete the site-of-origin community, use the no set extcommunity command.

Parameters

as4 ASN4:NN	Enter the keyword `as4` then the 4-octet AS specific extended community number in the format ASN4:NN (4-byte AS number:2-byte community value).
ASN:NNNN	Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2-byte AS number:4-byte community value).
IPADDR:NN	Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community value).
non-trans	(OPTIONAL) Enter the keywords `non-trans` to indicate a non-transitive BGP extended community.

Defaults

none

Command Modes

ROUTE MAP (config-route-map)

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If the set community rt and soo are in the same route-map entry, the behavior defines as:

If the rt option comes before soo, with or without the additive option, soo overrides the communities rt sets.
If the rt option comes after soo, without the additive option, rt overrides the communities soo sets.
If the rt with the additive option comes after soo, rt adds the communities soo sets.

Related Commands

set extcommunity rt — sets the extended community route origins using the route-map.