Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

dot1x server-timeout

Configure the amount of time after which exchanges with the server time-out.

Syntax

dot1x server-timeout seconds

To return to the default, use the no dot1x server-timeout command.

Parameters

seconds

Enter a time-out value in seconds. The range is from 1 to 300, where 300 is implementation dependant. The default is 30.

Defaults

30 seconds

Command Modes

INTERFACE

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When you configure the dot1x server-timeout value, take into account the communication medium used to communicate with an authentication server and the number of RADIUS servers configured. Ideally, the dot1x server-timeout value (in seconds) is based on the configured RADIUS-server timeout and retransmit values and calculated according to the following formula: dot1x server-timeout seconds > (radius-server retransmit seconds + 1) * radius-server timeout seconds.

Where the default values are as follows: dot1x server-timeout (30 seconds), radius-server retransmit (3 seconds), and radius-server timeout (5 seconds).

For example:

Dell(conf)#radius-server host 10.11.197.105 timeout 6
                                                Dell(conf)#radius-server host 10.11.197.105 retransmit 4
                                                Dell(conf)#interface tengigabitethernet 2/1
                                                Dell(conf-if-te-2/1)#dot1x server-timeout 40