Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

dcbx version

Configure the DCBX version used on the interface.

Syntax

dcbx version {auto | cee | cin | ieee-v2.5}

To remove the DCBX version, use the no dcbx version {auto | cee | cin | ieee-v2.5} command.

Parameters

auto | cee | cin | ieee-v2.5

Enter the DCBX version type used on the interface, where:

auto: configures the port to operate using the DCBX version received from a peer.
cee: configures the port to use CEE (Intel 1.01).
cin: configures the port to use Cisco-Intel-Nuova (DCBX 1.0).
ieee-v2.5: configures the port to use IEEE 802.1az (Draft 2.5).

Defaults

Auto

Command Modes

INTERFACE PROTOCOL LLDP

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.3(0.0)	Introduced on the FC Flex IO module installed in the M I/O Aggregator.

Usage Information

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX configuration on a port, use the show interface dcbx detail command.