Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip bgp dampened-paths

View BGP routes that are dampened (non-active).

Syntax

show ip bgp [ ipv4 unicast] dampened-paths

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip bgp damp command shown in the following example.

Field	Description
Network	Displays the network ID to which the route is dampened.
From	Displays the IP address of the neighbor advertising the dampened route.
Reuse	Displays the hour:minutes:seconds until the dampened route is available.
Path	Lists all the ASs the dampened route passed through to reach the destination network.

Example

Dell>show ip bgp dampened-paths
                                             BGP table version is 210708, local router ID is 63.114.8.2
                                             Status codes: s suppressed, d damped, h history, * valid, > best
                                             Path source: I - internal, a - aggregate, c - confed-external, r - redistributed, n - network
                                             Origin codes: i - IGP, e - EGP, ? - incomplete
                                             Network      From       Reuse       Path
                                             Dell>