Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug ip rip

Examine RIP routing information for troubleshooting.

Syntax

debug ip rip [ interface | database | events [ interface] | packet [interface] | trigger]

To turn off debugging output, use the no debug ip rip command.

Parameters

interface	(OPTIONAL) Enter the interface type and ID as one of the following: For a Port Channel interface, enter the keywords `port-channel` then a number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information. For a VLAN, enter the keyword `vlan` then a number from 1 to 4094.
database	(OPTIONAL) Enter the keyword `database` to display messages when there is a change to the RIP database.
events	(OPTIONAL) Enter the keyword `events` to debug only RIP protocol changes.
trigger	(OPTIONAL) Enter the keyword `trigger` to debug only RIP trigger extensions.

Command Modes

EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.