Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

logging version

Displays syslog messages in a RFC 3164 or RFC 5424 format.

Syntax

logging version {0|1}

Defaults

0

Command Modes

CONFIGURATION

Supported Modes

Full–Switch Mode

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.5(0.0)	Introduced on the MXL.

Usage Information

To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version command in configuration mode. By default, the system log version is set to 0.

The following describes the two supported log messages formats:

0 – Displays syslog messages format as described in RFC 3164, The BSD syslog Protocol
1 – Displays SYSLOG message format as described in RFC 5424, The Syslog Protocol

Example

Dell(conf)#
                                             logging version ?
                                             <0-1> Select syslog version (default = 0) 
                                             Dell(conf)#
                                             logging version 1