Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

set

Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.

Syntax

set {ip-dscp value | mac-dot1p value}

Parameters

ip-dscp value	(OPTIONAL) Enter the keywords `ip-dscp` then the IP DSCP value. The range is from 0 to 63.
mac-dot1p value	Enter the keywords `mac-dot1p` then the dot1p value. The range is from 0 to 7.

Defaults

none

Command Modes

CONFIGURATION (conf-qos-policy-in)

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

After the IP DSCP bit is set, other QoS services can then operate on the bit settings.