Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip rip send version

To send a specific version of RIP, set the interface. The version you set on the interface overrides the version command in ROUTER RIP mode.

Syntax

ip rip send version [1] [2]

To return to the default value, use the no ip rip send version command.

Parameters

1	(OPTIONAL) Enter the number `1` for RIP version 1. The default is RIPv1.
2	(OPTIONAL) Enter the number `2` for RIP version 2.

Defaults

RIPv1

Command Modes

INTERFACE

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To enable the interface to send both version of RIP packets, use the ip rip send version 1 2 command.

Related Commands

ip rip receive version — sets the RIP version for the interface to receive traffic.

version — sets the RIP version for the switch software.