Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug ip bgp ipv6 unicast soft-reconfiguration

Enable soft-reconfiguration debugging for IPv6 unicast routes.

Syntax

debug ip bgp [ ipv4-address | ipv6-address | peer-group-name] ipv6 unicast soft-reconfiguration

To disable debugging, use the no debug ip bgp [ ipv4-address | ipv6-address | peer-group-name] ipv6 unicast soft-reconfiguration command.

Parameters

ipv4-address \| ipv6-address	Enter the IP address of the neighbor on which you want to enable soft-reconfiguration debugging.
peer-group-name	Enter the name of the peer group on which you want to enable soft-reconfiguration debugging.
ipv6 unicast	Debug soft reconfiguration for IPv6 unicast routes.

Defaults

Disabled.

Command Modes

EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If no neighbor is specified, debug is turned on for all neighbors.

Related Commands

show ip bgp ipv6 unicast dampened-paths — views BGP dampened routes.