Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

intf-type cr4 autoneg

Set the interface type as CR4 with auto-negotiation enabled.

Syntax

intf-type cr4 autoneg

If you configure intf-type cr4 autoneg, use the no intf-type cr4 autoneg command to set the interface type as cr4 with autonegotiation disabled.

Defaults

Not configured

Command Modes

CONFIGURATION

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

If you configure interface type as CR4 with auto-negotiation enabled, also configure CR4 with auto-negotiation. Many DAC cable link issues are resolved by setting the interface type as CR4.

Related Commands

interface — configures a physical interface.

interface port-channel — configures a port channel group.