Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip ospf routes

Display routes OSPF calculates and stores in OSPF RIB.

Syntax

show ip ospf process-id routes

Parameters

process-id

Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process.

Defaults

none

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This command is useful in isolating routing problems between the OSPF and the RTM. For example, if a route is missing from the RTM/FIB but is visible from the display output of this command, the problem is with downloading the route to the RTM.

This command has the following limitations:

The display output is sorted by prefixes; intra-area ECMP routes are not displayed together.
For Type 2 external routes, Type 1 cost is not displayed.

Example

Dell#show ip ospf 100 route
                                             
                                             Prefix        Cost Nexthop   Interface Area  Type
                                             1.1.1.1        1   0.0.0.0   Lo 0      0     Intra-Area
                                             3.3.3.3        2   13.0.0.3  Te 0/4    1     Intra-Area
                                             13.0.0.0       1   0.0.0.0   Te 0/4    0     Intra-Area
                                             150.150.150.0  2   13.0.0.3  Te 0/4    -     External
                                             172.30.1.0     2   13.0.0.3  Te 0/4    1     Intra-Area
                                             Dell#