Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip igmp access-group

To specify access control for packets, use this feature.

Syntax

ip igmp access-group access-list

To remove the feature, use the no ip igmp access-group access-list command.

Parameters

access-list

Enter the name of the extended ACL (16 characters maximum).

Defaults

Not configured

Command Modes

INTERFACE (conf-if- interface-slot/port)

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The access list accepted is an extended ACL. To block IGMP reports from hosts, on a per-interface basis based on the group address and source address that you specify in the access list, use this feature.