Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

pfc no-drop queues

Configure the port queues that still function as no-drop queues for lossless traffic.

Syntax

pfc no-drop queues queue-range

To remove the no-drop port queues, use the no pfc no-drop queues command.

Parameters

queue-range

Enter the queue range. Separate the queue values with a comma; specify a priority range with a dash; for example, pfc no-drop queues 1,3 or pfc no-drop queues 2-3. The range is from 0 to 3.

Defaults

No lossless queues are configured.

Command Modes

INTERFACE

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The maximum number of lossless queues globally supported on the switch is two.

The following lists the dot1p priority-queue assignments.

dot1p Value in the Incoming Frame	Description heading
0	0
1	0
2	0
3	1
4	2
5	3
6	3
7	3