Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

protocol-tunnel

Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.

Syntax

protocol-tunnel {rate-limit rate| stp}

To disable protocol tunneling for a Layer 2 protocol, use the no protocol-tunnel command.

Parameters

rate-limit rate	Enter the keyword `rate-limit` then a number for the rate-limit for tunneled packets on the VMAN. The range is from 64 to 320.
stp	Enter the keyword `stp` to enable protocol tunneling on a spanning tree, including STP, MSTP, RSTP, and PVST.

Defaults

none

Command Modes

CONF-IF-VLAN

Supported Modes

Full–Switch Mode

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell#conf
                                             Dell(conf)#interface vlan 2
                                             Dell(conf-if-vl-2)#vlan-stack compatible
                                             Dell(conf-if-vl-2)#member Te1/2-3
                                             Dell(conf-if-vl-2)#protocol-tunnel stp
                                             Dell(conf-if-vl-2)#protocol-tunnel enable

Related Command

show protocol-tunnel — displays tunneling information for all VLANs.