Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

priority-list

Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy.

Syntax

priority-list value

To remove the priority list, use the no priority-list command.

Parameters

value

Enter the priority list value. Separate priority values with a comma; specify a priority range with a dash; for example, priority-list 3,5-7. The range is from 0 to 7.

Defaults

none

Command Modes

PRIORITY-GROUP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

By default:

All 802.1p priorities are grouped in priority group 0.
100% of the port bandwidth is assigned to priority group 0. The complete bandwidth is equally assigned to each priority class so that each class has 12 to 13%.
- NOTE: Please note that Dell Networking does not recommended to use this command as it has been deprecated in the current 9.4(0.0) release. A warning message appears when you try to run this command indicating that you have to use the dcb-map commands in the future.