Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

dscp

Sets the number of specific DSCP values for a color map profile to yellow or red.

Syntax

dscp {yellow | red} [ list-dscp-values]

To remove a color policy map profile, use the no dscp {yellow | red} [ dscp-list]command.

Parameters

Yellow	Enter the `yellow` keyword. Traffic marked as yellow delivers traffic to the egress queue which either transmits the packet if it has available bandwidth or drops the packet due to no ability to send.
Red	Enter the `red` keyword. Traffic marked as red is dropped.
dscp-list	Enter a list of IP DSCP values. The dscp-list parameter specifies the full list of IP DSCP value(s) for the specified color. Each DSCP value in a list is separate values by commas – no spaces (1,2,3) or indicates a list of values separated by a hyphen (1-3). Range is `0` to `63`.

Defaults

None

Command Modes

CONFIG-COLOR-MAP

Supported Modes

Full–Switch

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.7(0.0)	Introduced on the S6000-ON.
9.5.0.0	Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

Usage Information

If the specified color-map does not exist, the Diffserv Manager (DSM) creates a color map and sets all the DSCP values to green (low drop precedence).

The default setting for each DSCP value (0-63) is green (low drop precedence). This command allows setting the number of specific DSCP values to yellow or red.

Important Points to Remember

All DSCP values that are not specified as yellow or red are colored green.
A DSCP value cannot be in both the yellow and red lists. Setting the red or yellow list with any DSCP value that is already in the other list results in an error and no update to that list is made.
Each color map can only have one list of DSCP values for each color; any DSCP values previously listed for that color that are not in the new DSCP list are colored green.

Example

Dell(conf-dscp-color-map)# dscp yellow 9,10,11,13,15,16

Related Commands

qos dscp-color-map — configures the DSCP color map

qos dscp-color-policy— configures a DSCP color policy