Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show running-config uplink-state-group

Display the current configuration of one or more uplink-state groups.

Syntax

show running-config uplink-state-group [ group-id]

Parameters

group-id

Displays the current configuration of all uplink-state groups or a specified group. The valid group-id values are from 1 to 16.

Defaults

none

Command Modes

EXEC
EXEC Privilege

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Supported on the M I/O Aggregator.

Example

Dell#show running-config uplink-state-group
                                             !
                                             no enable
                                             uplink state track 1
                                             downstream TengigabitEthernet 0/2,4,6,11
                                             upstream TengigabitEthernet 0/8, 12
                                             upstream PortChannel 1
                                             !
                                             uplink state track 2
                                             downstream TengigabitEthernet 0/1,3,5
                                             upstream TengigabitEthernet 0/9,10

Related Commands

show uplink-state-group — displays the status information on a specified uplink-state group or all groups.
uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.