Dell EMC OpenManage Essentials Version 2.5 User's Guide

Adding devices to repurpose and bare-metal devices group

Adding devices to the Repurpose and Bare Metal Devices group is a prerequisite for deploying either a configuration template or a network ISO image on those devices.

  • CAUTION: Ensure that only the appropriate devices are added to the repurpose and bare-metal devices group. After deploying a configuration template on a repurpose and bare-metal device, it may not be possible to revert the device to its original configuration.

To add devices to the repurpose and bare-metal devices group:

  1. Click Deployment > Deployment Portal .
  2. In the Repurpose and Bare Metal Devices tab, click Modify Devices. The Modify Devices of the Repurpose and Bare Metal Device Group window is displayed.
  3. From the All Applicable Devices tree, select the devices that you want to add to the Repurpose and Bare Metal Devices group.
  4. Click Finish. The devices are listed in the Repurpose and Bare Metal Devices tab in the right pane, and in the Repurpose and Bare Metal Devices group in the device tree.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\