Dell NetWorker 19.9 Administration Guide

Installing the SCSI pass-through driver

The following procedure describes how to use SAM terminal mode to install a GSC, HSC, or PCI pass-through driver.

1. Select Kernel Config and press Enter.
2. Select Drivers and press Enter.
3. Select the SCSI_ctl driver by selecting SCTL from the list.
   If the current state is in, go to step 9. Otherwise, select any unreserved name for the device. For example, do not select a name such as /dev/null.
4. From the Actions menu, select Add Drivers to Kernel, and press Enter.
5. From the Actions menu, select Create a New Kernel, and press Enter.
   A confirmation message appears.
6. Specify Yes, and press Enter.
   The Creating Kernel message appears, followed by the Move Kernel message.
7. Select OK, and press Enter.
   The system reboots.
8. Verify that the spt was successfully installed by typing the following command:
   ioscan -kfn
9. Verify that the driver has claimed the autochanger.
   If the autochanger has been claimed, CLAIMED should appear under the S/W State header. If not, verify that the installation completed correctly.
10. If the device entry was defined by the operating system, use the OS-defined entry and continue to verify the installation.