Dell Storage Manager 2020 R1 Administrator's Guide

Add Ports to an iSCSI Fault Domain

After you connect additional iSCSI ports to an existing iSCSI network, add the iSCSI ports to the fault domain that corresponds to the network.

1. If the Dell Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2. Click the Storage tab.
3. In the Storage tab navigation pane, expand Fault Domains, then expand iSCSI and click the fault domain.
4. In the right pane, click Edit Settings.
   The Edit Fault Domain Settings dialog box opens.
5. In the Ports table, click Add Ports to Fault Domain.
   The Add Ports to Fault Domain dialog box opens.
6. In the Select the ports to add table, select the iSCSI ports to add to the fault domain. All iSCSI ports in the fault domain should be connected to the same Ethernet network.
7. (Virtual fault domain only) Assign a VLAN IP address to each selected port by editing the corresponding field in the VLAN IP Address column. Each port must have an IP address in the same network as the iSCSI control port.
8. Click OK to close the Add Ports to Fault Domain dialog box.
9. Click OK.